Assembly was pretty easy. I did need to solder a Deans connector onto the speedo though as I don't use EC3's, which is the connector it came with. The hardest part was deciding how to route the servo wires from the wing into the fuselage and keep them tidy. I also needed to figure out how to tape the 2 antenna wires in a 90 deg position to each other. I ended up orienting the short antenna up and routing the long antenna towards the back of the plane in parallel to the fuselage. This way the 2 antennas were 90 degrees to each other.
After figuring that out, I plugged in the battery and tested the control surfaces, flaps, and landing gear. The retractable landing gear was cool!
What am I getting myself into?!?
No comments:
Post a Comment